Desanding plant is design for bored pile & TBM on construction with economy option and very compact design for small footprint. AIPU desanding plant can be used for economy option as HDD mud recycling system. The desanding plant is design for flexible working and installation to suit bored pile, TBM or HDD mud recycling system.

Desanding Plant Working Procedure

1. A set of submersible slurry pump will pit up mud from mud pit, the length of pump under fluids normally 800mm to 1500mm. Solids particles not allowed larger than 1cm to protect pump impeller, so there is a protect mesh installed at mump inlet.
2. The mud will goes into shale shaker bottom deck by a PU material shaker screen for big solids separation. There are 2 panels screen, 3 panels screen or 4 panels screen for the bottom deck depending on mud flow requirement. The solids particles will discharge out through shaker screen and clean mud drop into mud tank compartment.
3. There is a pump pick up mud from mud tank compartment and feed into cyclone, the solids out of cone will drop on top of shaker deck for solids drying and clean mud over flow from cyclone will flow into a intermediate box. There is an auto control to allow clean mud goes into mud tank compartment or flow away.

Model Options Of Desanding Plant

 

Model	Capacity	Separation Size	Treated Water Content	Power	Weight	Dimention
APMC50	50m³/h	25μm	30%	18kW	3000kg	3600×2100×3750mm
APMC100	100m³/h	40μm	30%	33.44kW	3200kg	3150×2100×2500mm
APMC200	200m³/h	40μm	50%	48.88kW	3750kg	4200×2200×3800mm
APMC250	250m³/h	40μm	30%	58kW	5500kg	4000× 2250× 2800mm
APMC500	500m³/h	70μm	30%	140kW	14000kg	9000×6000×6300mm
Note	Separation size can be custmized by change cyclone size or install decanter centrifuge for 2 microns